Arlington Times


Snohmoish County begins annual roadway resurfacing program

June 28, 2013 · 2:29 PM

MARYSVILLE — More than 11 miles of county roads in the Arlington, Marysville and Tulaip areas are among the 88 miles of roadway included in Snohomish County's annual roadway resurfacing program this year.

The county annually evaluates its entire road network in an effort to develop a multi-year plan for preserving and maintaining county roads in the most cost-effective way possible, according to county officials. This year the county will chip seal about 85 miles while paving another three lies of road with asphalt.

County Road Maintenance Division crews will use approximately 8,200 tons of asphalt to patch potholes and improve rough or failing pavement, as well as to complete the chip seal work. Chip sealing extends the life of the road surface for an addition seven to 10 years. Typically crews are able to complete the work quickly to minimize impacts to residents and businesses.

The chip seal process consists of:

The road is immediately usable, and during the following week, most remaining crushed rock is pressed into the asphalt by vehicles driving on the road. A temporary 20-mph speed limit will be enforced during that time. Crews will return within a week to sweep up any loose chips and replace pavement striping.

Chip sealing is scheduled to begin July 8 in various south county neighborhoods. The Road Maintenance paving crews will work from east to west in July. During August, they will work their way north and northwest. Though work progress and schedule are weather dependent, all chip seal work should be complete by mid-September.

The overlay work is now underway and being done by Cemex.

In Arlington, there are nine road locations totaling 4.87 miles. In Marysville there are two road locations totaling 1.28 miles and in the Tulalip/Warm Beach area there are 12 road locations totaling 5.16 miles.

Commenting Rules

© Sound Publishing, Inc.
All rights reserved.
Our Titles | Work With Us